top of page
accessories assembly instructions
Pistol Display Stand

Pistol Display stand assembly

Please read and follow all instructions.

Below you will see a list of parts included in the package.

1= base

1= upright

1= brass screw

                                                                                                                                                                     USING A  #3 PHILLIPS SCREWDRIVER (NOT INCLUDED)

Upright
20180518_110039.jpg
base
20180518_112635.jpg
fully assembled
img_5821355836_1523759789_thumb200.jpg
INSTALL AND TIGHTEN BRASS SCREW 
WHILE holding upright in mortise that is cut into the base and KEEPING TWO PRE-DRILLED HOLES IN UP-RIGHT AND BASELINED UP, TIGHTEN BRASS SCREW, PLEASE DO NOT OVER-TIGHTEN SCREW, JUST SNUG IT UP, YOU MAY ADD A LITTLE WOOD GLUE UNDER THE UPRIGHT TO HELP KEEP IT TIGHT AND IN PLACE permanently.
bottom of page